The Carbon Copy Analog Delay delivers rich, warm bucket-bridgade delay with up to 600ms of delay time and modulation.
This pedal can be powered by a 9-volt battery, a Dunlop ECB003 9-volt adapter, or the DC Brick™, Iso-Brick™, and Mini Iso-Brick™ power supplies (not included).
M169 CARBON COPY® ANALOG DELAY DESCRIPTION • 100% analog bucket- brigade technology • Up to 600ms of delay with switchable modulation •Internally adjustable modulation circuit • True bypass
POWER The MXR Carbon Copy Analog Delay is powered by one 9-volt battery (remove bottom plate to install), a 9-volt AC Adapter such as the Dunlop ECB003/ECB003EU or a DC Brick™ power supply
DIRECTIONS • Run a cable from your guitar to the Carbon Copy’s INPUT jack and another cable from the Carbon Copy’s OUTPUT jack to your amplifier. • Start with all controls at 12 o’clock. • Turn the effect on by depressing the footswitch. • Rotate the REGEN knob clockwise to increase the number of repeats or counterclockwise to decrease it. SPECIFICATIONS Input Impedance1 MΩ Output Impedance1 kΩ Max Input Level +5 dBV at 500 Hz Max Output Level+8 dBV Noise Floor*Mix at Max CW-96 dBV Mix at Max CCW-104 dBV Delay Distortion <1% at 1 kHz,-5 dBV InputDelay Time20 ms to 600 ms Noise Reduction2:1 ratio Modulation Speed 0.2 Hz to 2.2 Hz Bypass True Hardwire Current Draw26 mA Power Supply9 volts DC *Regen at max CCW, A-weighted • Rotate the MIX knob clockwise to increase the ratio of wet to dry signal or counterclockwise to decrease it. Fully clockwise results in 100% wet signal while fully counterclockwise results in 100% dry signal. • Rotate the DELAY knob clockwise to increase delay time or counterclockwise to decrease it. • Push in the MOD switch to add modulation to your delay signal. Modulation width and speed can be adjusted internally with a 2mm slotted screwdriver
CONTROLS MOD switch toggles modulation on/off (blue LED indicates on) MIX knob controls blend of wet and dry signals REGEN knob sets number of repeats DELAY knob sets delay time FOOTSWITCH toggles effect on/bypass (blue LED indicates on)
